X-Git-Url: https://git.ucc.asn.au/?a=blobdiff_plain;f=research%2FTCS%2Finterface.py;fp=research%2FTCS%2Finterface.py;h=4705c9e48d0f66dec3e67e217ef1b823b015a9a6;hb=ebd894f79279423eed1885cc3370f522edb1d402;hp=cfff9d313e9179287bfedd66c02ff5a4398978c1;hpb=91691854b850254e754e68a7d90700e163a572d2;p=matches%2Fhonours.git

diff --git a/research/TCS/interface.py b/research/TCS/interface.py
index cfff9d31..4705c9e4 100755
--- a/research/TCS/interface.py
+++ b/research/TCS/interface.py
@@ -35,7 +35,7 @@ calibrate = {
 }
 
 # TODO: Adjust aqcuisition parameters here
-aquire = { "DAC_Sweep" : "0.0 + 10.0*int(step)", # DAC Sweep value (t is in STEPS, not seconds!)
+aquire = { "DAC_Sweep" : "0.0 + 50.0*int(step)", # DAC Sweep value (t is in STEPS, not seconds!)
 	"ADC_Averages" : 200,
 	#"ADC_Vi" : 5, # ADC channel to read back Vi (set by DAC) through
 	#"ADC_Is" : 4, # ADC channel to read back Is through
@@ -48,7 +48,7 @@ aquire = { "DAC_Sweep" : "0.0 + 10.0*int(step)", # DAC Sweep value (t is in STEP
 
 #Setup the serial connection parameters
 ser = serial.Serial(
-	port="/dev/ttyUSB1", # Modify as needed (note: in linux need to run `sudo chmod a+rw /dev/ttyUSBX' to set permissions)
+	port="/dev/ttyUSB0", # Modify as needed (note: in linux need to run `sudo chmod a+rw /dev/ttyUSBX' to set permissions)
 
 	# Do not change the values below here (unless AVR butterfly is reprogrammed to use different values)
 	baudrate=4800,
@@ -62,7 +62,7 @@ ser = serial.Serial(
 #Using an ordered dictionary, so results will be determined (or prompted for) in this order.
 # Put things that are being changed a lot near the top of the list.
 parameters = odict.odict([
-	("Chamber Pressure" , None), # Chamber pressure now automatically determined
+	#("Chamber Pressure" , None), # Chamber pressure now automatically determined
 	("Venault Voltage" , None),
 	("Title" , None),
 	("Comment" , None),