}
# TODO: Adjust aqcuisition parameters here
-aquire = { "DAC_Sweep" : "0.0 + 10.0*int(step)", # DAC Sweep value (t is in STEPS, not seconds!)
+aquire = { "DAC_Sweep" : "0.0 + 50.0*int(step)", # DAC Sweep value (t is in STEPS, not seconds!)
"ADC_Averages" : 200,
#"ADC_Vi" : 5, # ADC channel to read back Vi (set by DAC) through
#"ADC_Is" : 4, # ADC channel to read back Is through
#Setup the serial connection parameters
ser = serial.Serial(
- port="/dev/ttyUSB1", # Modify as needed (note: in linux need to run `sudo chmod a+rw /dev/ttyUSBX' to set permissions)
+ port="/dev/ttyUSB0", # Modify as needed (note: in linux need to run `sudo chmod a+rw /dev/ttyUSBX' to set permissions)
# Do not change the values below here (unless AVR butterfly is reprogrammed to use different values)
baudrate=4800,
#Using an ordered dictionary, so results will be determined (or prompted for) in this order.
# Put things that are being changed a lot near the top of the list.
parameters = odict.odict([
- ("Chamber Pressure" , None), # Chamber pressure now automatically determined
+ #("Chamber Pressure" , None), # Chamber pressure now automatically determined
("Venault Voltage" , None),
("Title" , None),
("Comment" , None),